iorewflix.blogg.se - Kepserverex command line

Kepserverex command line how to#
Kepserverex command line drivers#
Kepserverex command line driver#

To request a specific message revision, Please enter the message revision number of the message.

Set the parameters used to request different versions of messages from the device.

Kepserverex command line driver#

Failed after Fail After ： This parameter specifies that the driver attempts to send “ Keep active ” The number of messages.

The default setting is 1000 millisecond （1 second ）. The effective range is 100 To 30000 millisecond.

Reply timeout Reply Timeout ： This parameter specifies that the driver waits for the Time to keep the response of active messages.

This is because the device has shut down the connection. īe careful Caution ： If “ Keep active ” The interval is set to greater than 10 Value of seconds, The driver may publish in the event log “ equipment No response ” news.

poll time - Poll Time ： This parameter specifies that the driver sends “ Keep active ” Inactive time before the message.

If the device doesn't respond Read, The driver will always set the error state.

Set all DNR Error status for - Set Error State for All DNRs ： When selected, If the device is not set up, The driver will set the error state Respond to （DNR） Write or subscribe to a request.For open protocols, The default setting is 4545. Port number - Port Number: ： This parameter specifies that the driver is connected to The port number that will be used when the device is used.The parameters are described as follows ： Ĭommunication parameters Communications Parameters The driver supports at most 100 Channels and 1024 Devices. Maximum number of channels and devices Maximum Number of Channels and Devices The driver has been tested by Stanley QAα Controller and Atlas Copco Power focus.

Kepserverex command line drivers#

Torque Tool Ethernet drivers are designed to support Torque Tool Open protocol for any device. It is designed to work with all devices that support the torque tool open protocol. The torque tool Ethernet driver provides a way to connect the torque tool Ethernet device to OPC Client applications （ Include HMI、SCADA、Historian、MES、ERP And countless custom applications ） A reliable way to. What error messages are generated by the torque tool Ethernet driver ？

Kepserverex command line how to#

How to reference the data position in the Ethernet device of torque tool ？ What data types does the torque tool Ethernet driver support ？ How to get the best performance from the driver ？ĭata type description Data Types Description Optimize torque tool Ethernet communication Optimizing Your Torque Tool Ethernet Communications How do I configure the devices used with this driver ？ What is the torque tool Ethernet driver ？ Optimize communication - Optimizing Communicationsĭata type description - Data Types DescriptionĪddress description - Address DescriptionsĬommand set ： Auto disable settings - Auto-Disable SettingsĬommand set ： Job number data - Job Number DataĬommand set ： Last tightening result - Last Tightening ResultsĬommand set ： Multi axis results - Multi Spindle ResultsĬommand set ： Old tightening results - Old Tightening ResultsĬommand set ： Parameter set data - Parameter Set DataĬommand set ： Parameter set number - Parameter Set NumbersĬommand set ： Selected parameter set - Parameter Set Selected Communication parameters -Communications Parameters